![]() ![]() Configure your GPS to work with Windows.To work around this you can use Michael Chourdakis’ excellent GPSDirect driver that acts as a layer between a legacy GPS device that sends NMEA data through a COM port, and the Sensor and Location Platform. I only know of the USB GPS Devices from ublox. GPS in actionĪs of this writing, there are very few devices compatible with the new framework out there. This works the same for any sensor, by the way. ![]() This worked OK in my opinion, but with the new framework the GPS device, or sensor, is exposed directly to the OS. Up until now the usual way to connect a GPS device to your computer was for it to emulate a COM port and then send standard NMEA GPS data to the port at a specified baud rate. a GPS device to track your location, a light sensor to dynamically adjust your screen brightness based on the ambient lighting, an accelerometer to use for games etc. In short it is a system that enables the OS to utilize different sensors e.g. A successful result would show the NMEA data streaming in as indicated below.Windows 7 has a new framework the Windows Sensor and Location Platform. Once downloaded, run the application and select the serial connection type, enter in the operating system assigned COM port (you may ignore the baud rate), then click “Open”. A simple test of streaming NMEA can be achieved by downloading a serial terminal client like Putty ( ).You will use this COM port when attaching third party software to the Bad Elf accessory. The COM port assigned by the Windows operating system for this Bad Elf receiver is COM8. Click on the icon to the left of the Bad Elf GPS #XXXXXXX.Next, you will need to determine the COM port assigned by the operating system. Once this action is completed, the message “Ready to pair” will change to “Paired” as shown below.Īt this point you have successfully paired your Bad Elf receiver with your Windows computer. Pairing must be confirmed on both the computer and the Bad Elf receiver to complete the process. Press the bottom button on the Bad Elf receiver and confirm the pairing on the Windows computer screen as well.The Bad Elf receiver LCD screen displays a message asking you to confirm a pairing PIN, which should match. Within 5-10 seconds, you should see a prompt on both the Windows computer. Select your Bad Elf accessory from the list, and tap the Pair button.If your Bad Elf accessory is turned on, you should see something like Bad Elf GPS #12345 (with your unit's serial number) in the list. Note, the Bluetooth option may not be displayed.Select Bluetooth Devices from the icon list in the lower right hand portion of your desktop.This process will only have to be done once and does not need to be repeated in the future. To pair the GPS Pro/Pro+/GNSS Surveyor with your Windows 10 computer please follow the instructions below. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |